Iso 1217 annex e

Your Alert Profile lists the documents that will be monitored. If the document is revised or amended, you will be notified by email. You may delete a document from your Alert Profile at any time. This standard is also available to be included in Standards Subscriptions.

Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. Subscription pricing is determined by: the specific standard s or collections of standards, the number of locations accessing the standards, and the number of employees that need access. As the voice of the U. Available for Subscriptions.

Add to Alert PDF. Please first log in with a verified email before subscribing to alerts. A compressor rated at ACFM operating at these conditions would put about 75 pounds of air into the system every minute. If the facility was in a location where the ambient pressure was Under those conditions, with a 90 PSIG operating pressure, the pressure dew point would be Water vapor drawn into the compressor would never see a temperature lower than that and no water would condense.

If the facility happened to be in Denver, some calculations would have to be made to determine whether the compressor would actually operate the device. The ambient pressure in Denver is about Multiplying these two correction factors together give you the total change in density of the ambient air between the site conditions and the standard conditions. The air on that summer day in Denver is only This will cause some of the water vapor to condense into a liquid, removing its portion of the inlet air stream from what is available at the discharge point of the dryer.

It actually reduces the available inlet air stream by about CFM. The bucket size did not change but what went into the bucket did. At standard conditions, a full bucket held 75 pounds of air and in Denver the bucket is full with just To find out what size compressor to use to deliver cubic feet of air at the reference condition, start by adding 17 to the Use 17 or 18 instead of the 16 used above because the compressor is going to pull in more ambient air and thus more water vapor.

Now divide by the correction factors. This calculation results in the volume required at the stated summer conditions to deliver the same mass as cubic feet of air at standard conditions. In the winter, colder air is more dense and the correction factor may go above 1.

Changes in ambient temperature are why some marginal applications work fine in the winter and struggle in the summer. A refrigerated dryer, for example, is only capable of cooling a certain number of molecules of air down to its specified dew point. If the document is revised or amended, you will be notified by email. You may delete a document from your Alert Profile at any time.

This standard is also available to be included in Standards Subscriptions. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. Subscription pricing is determined by: the specific standard s or collections of standards, the number of locations accessing the standards, and the number of employees that need access. As the voice of the U. Most recent.

Available for Subscriptions. Add to Alert PDF. Please first log in with a verified email before subscribing to alerts.